In-Building & DAS Engineering

ibs-building solutionsTS2I International Limited provides complete in-building wireless network design, optimization, installation, commissioning and testing services for all major wireless technologies including LTE, WiMAX, HSPA+, UMTS, EVDO, GSM, CDMA, TDMA, GPRS and iDEN

Our approach to performance is to tune the network to cater to immediate needs and come up with plans to mitigate problems on a long term.

We achieve these goals by suggesting network parameter changes or/and hardware inspection to resolve the problem in short term. If there are design changes required our design team can work with the operators to make that happen.

TS2I International Limited are also able to perform your quality of experience in-building solutions by supporting your team or your customer to design, optimize and install your Distrubuated Antenna Solutions per the service requiements is in need.


In-Building Network Design

  • In-Building Site Design
  • RF In-Building Network Dimensioning
  • RF In-Building Site Integration Support
  • RF In-Building Construction Management

In Building Network Optimization

  • Core Network Performance
  • Parameters Audit & Tuning
  • RF Pre and Post Launch Optimization

In-Building Walk Testing

TS2I International Limited works with the Operators to perform benchmarking of their Network. We perform walk tests in the buildings to identify the areas where our Clients could have poor RSSI and/or bad SQE compared to their competitors. In conjunc-tion with its clients, TS2I International Limited can come up with a plan to improve the coverage with optimization of the general area and/ or proposing design enhancements in the area.

Continuous Wave (CW) Testing

TS2I International Limited works with the Operators to perform New Site CW Walk testing to gauge the coverage from the proposed site beforehand, at different heights if needed. This testing allows the Operators to visualize if the proposed site would meet the Coverage.

Pre-Design Coverage Assessments

Prior to any RF design, it is important to understand and measure the extent of the existing coverage and limitations.

Design Modeling

Before going through the expense of building a system, CW testing can be used to make a “final check-up” of the proposed design to ensure optimal performance and the best quality of experience.

Acceptance Testing

Once a DAS or Small Cell network is installed, benchmarking is the best way to scientifically determine whether or not a system meets the required coverage objectives.